The Ten Tool Rule

Ten hand tools on one wall

They were my grandfather's, rolled up in canvas. Every build on this site uses only these, so you don't need a garage full of machines.

Ten hand tools laid out on a canvas roll

The ten

01

Hand plane

Takes off old varnish and makes edges straight. The one I'd keep if I could keep only one.

02

Chisel, wide

For notches and joints. Buy old, flatten the back once, keep it sharp.

03

Chisel, narrow

For tight corners and small joints.

04

Tenon saw

Straight cuts across the grain. A sharp old one beats a blunt new one.

05

Brace drill

Drills by hand, quietly. Old ones turn up at flea markets for little.

06

Mallet

Drives the chisel. Wood, not steel.

07

Marking gauge

Scratches a line parallel to an edge, so both sides of a joint match.

08

Spokeshave

Shapes curves, like chair legs and handles.

09

Rasp

Rounds edges and removes wood fast.

10

Square

Checks that a cut or a corner is 90 degrees. Everything starts with it.

The free PDF adds what to look for when you buy each one second-hand.

Saga sharpening a chisel on a stone by the window

Sharp beats new

A cheap old chisel, sharpened properly, cuts better than an expensive one straight out of the box. Most of my tools cost less than a takeaway.

A short sharpening guide is coming next.