Build · cross-lap joint

Christmas tree stand from two offcut beams

The neighbour's roof job left two pine beams in the skip. One cross-lap joint later, they hold the tree instead of feeding the stove.

Cost of new: €20–50 for a plastic standCost of this: one afternoon
Finished cross-shaped pine tree stand holding a spruce by a woodstove

What it is

Wood
Two pine beams, 70 × 70 mm, builder's offcuts
Joint
One cross-lap, 35 mm deep in each beam, no glue
Holds
The trunk sits in the centre, held by four short braces
Time
An afternoon
Level
Beginner who has used a saw and a chisel
70 mm 70 notch: 35 mm deep in each beam (half the thickness)

Tools

  • Tenon saw
  • Chisel, about the width of the notch
  • Mallet
  • Square
  • Marking gauge
  • Brace drill

About the ten tools →

How it goes together

  1. Mark both notchesLay one beam across the other and mark its width. Set the gauge to half the thickness, 35 mm, and mark the depth on both sides.
  2. Saw the shouldersCut down to the depth line on both edges of each notch, staying on the waste side.
  3. Chop and pareChop out the waste with the chisel and mallet, then pare the floor flat from both sides.
  4. Fit it dryThe beams should drop into each other and sit flush. Tight is better than loose: pare a little at a time.
  5. Add the bracesFix four short braces around the centre to hold the trunk upright.
Chisel on a pencil line across a pine beam
Chisel on the line
Two pine beams fitted together in a cross-lap joint
The joint, dry-fitted
Saga carrying a spruce home through the snow
Bringing the tree home

This stand has no water bowl. A cut tree dries out faster without water, so keep the room cool, check the needles, and keep it away from the stove and candles.

Free printable plan

Get the printable tree stand plan

Eight pages: both sizes, the water version, the cut list, every drawing and a build checklist you can tick off at the bench. Free.

Tell me where to send it and it's in your inbox in a minute. You'll also get my emails now and then, usually about a slow build. Unsubscribe anytime.

Send me the free plan

Watch it

The whole build in 16 seconds, no talking, just the chisel. On YouTube from Sunday 22 November.